Machine Knit Striped Cardigan

Another machine knit sweater! This time I adventured into a different type of yarn instead of the good old Caron simply soft. I actually found a bunch of wool yarn in goodwill for 1.59 each. So I bought all of them without thinking about what to make. Among them was 4 skeins of organic wool from the Full Belly Farm – two beige and two brown, 250 yds each. I thought together they would make a nice striped sweater. The funny thing about those wool – the sheeps on that farm must have rolled in the straw a LOT before they were sheared for this batch of yarn. There was SO many straws and dried grass stuck in the yarn. I picked them out as I balled the yarn, as I knitted, and still have to pick some out after I was done. But I cant complain that much given that they cost less than $10 total for organic wool!!

I knitted this on my knitting machine as usual (pattern below). I sewed two in-seam pockets in the side and I am so glad I did 🙂 The edges are all hand knit since the machine doesnt do anything than regular stockinette knit, which curls a lot.

Other than that, I really love the end result – its really warm and light and not too scratchy – I expect it to become softer with more wear too. This is the first time I used non-cheap yarn on my machine and it turned out beautifully – giving me confidence to try other expensive yarn on the machine next time!

(btw, my color/stripe inspiration for this sweater is here).

You can see the inseam pocket in above picture.

The front view is the least flattering since its just a rectangle on the bodice. I think i should do some shaping on my next try.

I LOVE the view from the back! Those stripes! *swooon*

 

Instruction/pattern for this cardigan:

2.5 tension, size 6 needle

back:

  • 2 out of 4 rods inserted
  • cast on 90 stitches with WY, knit 6 rows
  • K 10 rows, mark arm holes
  • K 40 more rows
  • put center 20 stitches on waste yarn
  • each shoulder will have 35 stitches
  • knitting 6 rows with WY on each shoulder, then take them off the machine

front (make 2 of opposite kinds)

  • 1 out of 4 rods inserted
  • cast on 35 with WY, knit 6 rows
  • knit 10 rows, mark arm holes
  • knit 40 more rows
  • knit 6 rows with waste yarn

join shoulder

sleeves:

  • bring out 56 stitches, and hook on between the markers
  • 1 out of 4 rods inserted
  • knit 20 time, reduce 2 stitch on third stitch on each side once – 54 stitches
  • knit 8 times,reduce 2 stitch on third stitch on each side once – 52 stitches
  • knit 8 times,reduce 2 stitch on third stitch on each side once – 50 stitcheS
  • knit 8 times,reduce 2 stitch on third stitch on each side once – 48 stitches
  • knit 8 times,reduce 2 stitch on third stitch on each side once – 46 stitches
  • knit 8 times,reduce 2 stitch on third stitch on each side once – 44 stitches
  • knit another 4 rows,  take it off the machine on a size 6 needle
  • start knitting with the right side here – knit 8 rows, bind off. (this is basically garter stitch)
stitch sleeve and side seams together, then hang the bottom together, total of 160 stitches onto the machine. Do the following ** please see notes below:
(**note: I actually have to do the three pieces separately for quite a few more rows, even though I bought 2 30-needle extension knit, because the sweater was too small to stretch out to the full 160 needle machine. I hate hand joining seams so I was trying to avoid that as much as possible – and I failed. If I were to do this again I may try knitting this bottom up instead. However, this allowed the side seam to be separated for a longer length below armpit – allowing me to stitch in a in-seam pocket).
  • 6 rows of dark
  • 4 rows of light
  • 8 rows of dark
  • 4 rows of light
  • 10 rows of dark
  • 4 rows of light
  • 12 rows of dark
  • 4 rows of light
  • 14 rows of dark
  • this is when i actually started knitting all 160 stitches at the same time. insert 3 rods for weight
  • 4 rows of light
  • 18 rows of dark
  • 4 rows of light
  • 26 rows of dark

Then take the sweater off the machine and onto size 6 knitting needle – do 8 rows of knitting (garter stitch) then bind off.

Hand join the sides together, maybe stitch in an inseam pocket.

pick up X stitches along the front and neckline. I actually dont remember how many I picked up, but I measured the garter stitch length on the bottom and the length of front&neckline to figure out how many stitches to pick up along the front&neckline (31 stitches for every 7 inches). Then I knitted about 14 times – when I almost ran out of yarn of one of the colors & then bind off. Note that I stitch colors every row so that I use light colors on top and dark on the bottom.

 

 

6 thoughts on “Machine Knit Striped Cardigan

  1. Fabulous sweater! You did well to pick out the twigs, they will cause endless itching. Sad how many companies interpret “organic’ as meaning scratchy wool full of vegetation. Actually organic wool can be the very softest, as the wool scales are preserved from harsh chemical treatment. But someone has to take out the twigs one way or another :-).

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

%d bloggers like this: